|
Test
Equipment
Please use the links below to learn more about these high quality products.
|
|
Universal Span Simulator USS-3100 |
 |
USS-3100
Front and Back Views
The Enginuity USS-3100
T1/HSDL Line Simulator
is a compact and transportable test fixture, used to train
installation and maintenance personnel in understanding end-to-end
T1, HDSL, HDSL2 and HDSL4 network circuit design.
The USS-3100 also provides the capability to simulate various
lengths of 24 AWG cable from 3Kft to 18Kft, and can facilitate
various line conditions and faults.
The USS-3100 provides the following capabilities:
- All
in one case, card
slots for Office Repeater (ORB), Span Repeaters (239 type),
Network Interface Unit (NIU) or (Smart Jack)
- Power
– Standard 120VAC Grounded Plug
- Individual
short, open and ground switches
for Tip and Ring on both pairs to identify any shorts, opens or
failed insulation in the cable
- Individual
line condition switches for
bridge taps, excessive loop length and load coils for Tip and
Ring on both pairs
- Supports
multiple
vendor plug-ins and technology for T1 and HDSL
- Loop
length selections in 3Kft increments, for each segment up to a
total span length of 18Kft
- Span
repeater slots for
up to (2) two 239 type repeaters or an HDSL doubler
|
 |
| |
Technical Document
|
VB-10075
CLEI Code: Pending
Video Balun is a passive device used to transform Video or data
signals from a 75 ohm coaxial cable to an unshielded twisted-pair (UTP)
category 2 (24 AWG) or higher grade wires.
|
Technical
Document |
GB101
The Enginuity GB-101 Dual DS1 Test Set provides two independent DS1
interfaces which allows dual monitoring and simultaneous
bi-directional circuit testing. An built-in intuitive Graphical User
Interface (GUI) is standard. It may also be used with an external
Palm PDA or PC/Laptop computer The unit provides Drop, Insert, and
Bypass testing capabilities. |
Technical
Document |
GB101DI
The Enginuity GB-101DI Dual DS1 Test Set provides two independent
DS1 interfaces which allows dual monitoring and simultaneous
bi-directional circuit testing. An built-in intuitive Graphical User
Interface (GUI) is standard. It may also be used with an external
Palm PDA or PC/Laptop computer The unit provides Drop, Insert, and
Bypass testing capabilities |
|
|
GB104
The Enginuity GB-104 Transmission Impairment Measuring System (TIMS)
Test Set with Signaling functions provides an intuitive Graphical
User Interface (GUI) for the user to a Palm PDA or a PC/Laptop
computer. In addition to the standard TIMS functions of tone
generation and measurement of frequency, level, and noise, this
unique and extremely flexible TIMS provides auto-sweep and
programmed tone insertion loss measurement from 20Khz to 2Mhz for
simplified xDSL line qualification.
|
Technical Document
|
GB310
The Enginuity GB-310 DS3, Dual DS1, DS0 Test Set provides a multi
functional test set that can do comprehensive DS3 tests, dual
independent DS1 tests, and DS0 tests. It includes an integrated
intuitive Graphical User Interface (GUI) or can be used with an
external Palm PDA or PC/Laptop computer. The GB-310DI adds signaling
TIMS functions of the GB104 to the GB-310. |
Technical Document
|
GB310DI
The Enginuity GB-310DI adds signaling TIMS functions of the GB104 to
the GB-310.
|
|
|
|
|
|
|
|
|
|
